Read entered vs cutlist panel dimensions

See why a panel's editable dimension can differ from the value that goes to the cutlist and board layout.

1. Every panel has two dimension sets: the value the designer entered (raw) and the finished value that goes to the cutlist and board layout (adjusted).

   ✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

2. For a flat panel, the adjusted value equals the entered value plus any panel extensions (extensions are ignored once a dimension is marked fixed) minus the depth of any profiles applied on that edge.

   For a curved panel, the adjusted value is instead the flattened blank length measured along the curved path, with the panel extensions already taken into account along that path.

3. For custom panels the editable dimension input always shows the entered value.

   ✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

4. When the cutlist value differs (for example a profile is applied), the input is relabelled 'Entered L' or 'Entered W' and a read-only 'L'/'W' row appears right below it showing the cutlist value, with an info tooltip that spells out both numbers and the reason for the difference.

   ✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

5. For non-custom panels (carcass panels etc.) the Dimensions section is read-only and always shows the cutlist value.

   ✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا