Extend or reduce a panel edge with extension parameters
Use the four directional extension fields to lengthen or shorten a panel edge, including negative values.
The extension parameters are offered in four directions — L (left), R (right), B (back) and F (front).
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاEntering a negative value reduces that edge, for example subtracting the carcass panel thickness on the front to shorten a vertical partition.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاIn panel construction, a positive value entered in a side's extension/reduction field extends the panel on that side, while a negative value reduces it.
The width and depth extension parameters are offered at panel level under the Construction tab.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاThe depth shown there is the carcass depth, which does not include the shutter thickness.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاThe dimensions displayed for a cabinet refer to the carcass only; shutter thickness, skirting and countertop are not included in those figures and must be accounted for separately when reading or entering measurements.
Carcass panels (left, right, top, bottom) can be extended from the panel-level extension parameters; the extension is entered as a directional shift (left/right/back/front) and the finished cutlist dimension reflects it. For curved panels, the cutlist and quotation width is reported as the flattened blank length — the developed length of the curved path, with the extensions already walked along that path — rather than the straight chord or the corner-unit bounding-box width.