Read entered vs cutlist panel dimensions

See why a panel's editable dimension can differ from the value that goes to the cutlist and board layout.

1. Every panel has two dimension sets: the value the designer entered (raw) and the finished value that goes to the cutlist and board layout (adjusted).

   ✓ ଅକ୍ଟୋବର 22, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

2. For a flat panel, the adjusted value equals the entered value plus any panel extensions (extensions are ignored once a dimension is marked fixed) minus the depth of any profiles applied on that edge.

   For a curved panel, the adjusted value is instead the flattened blank length measured along the curved path, with the panel extensions already taken into account along that path.

3. For custom panels the editable dimension input always shows the entered value.

   ✓ ଅକ୍ଟୋବର 22, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

4. When the cutlist value differs (for example a profile is applied), the input is relabelled 'Entered L' or 'Entered W' and a read-only 'L'/'W' row appears right below it showing the cutlist value, with an info tooltip that spells out both numbers and the reason for the difference.

   ✓ ଅକ୍ଟୋବର 22, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

5. For non-custom panels (carcass panels etc.) the Dimensions section is read-only and always shows the cutlist value.

   ✓ ଅକ୍ଟୋବର 22, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି