Inspect units and panels in the QC Mode tabs
Read the Units and Panels tabs to see annotations, rooms and where each material came from.
The Panels tab lists panels separately, which is why panel counts typically exceed unit counts.
✓ Проверено в продукте 19 октября 2026 г.
The Units tab also shows a Room column, so units can be inspected per room.
✓ Проверено в продукте 19 октября 2026 г.
Panels that belong to a cabinet carry both the cabinet and the panel annotation (e.g. C3.P7).
✓ Проверено в продукте 19 октября 2026 г.Custom or independent panels show only the panel annotation (e.g. P7).
✓ Проверено в продукте 21 октября 2026 г.
In QC mode the Panels tab can be searched and filtered by cabinet ID, panel type (e.g. shutter, back panel), laminate or edge band.
✓ Проверено в продукте 19 октября 2026 г.
Searching the Panels tab by a panel type such as "Shutter Panel" lists all matching panels across the project; the header check box then selects them all.
✓ Проверено в продукте 19 октября 2026 г.
Scrolling through the matching panels shows each panel's core material so a wrongly applied ply can be spotted.
✓ Проверено в продукте 19 октября 2026 г.Shutters can be checked the same way by searching the shutter panel and reading its core material.
✓ Проверено в продукте 19 октября 2026 г.Back panels whose core source is the carcass core ('Carcass Core') follow the carcass material automatically; a back panel with its own core ('Custom Core', such as a 6 mm back) keeps it.
✓ Проверено в продукте 21 октября 2026 г.