Inspect units and panels in the QC Mode tabs
Read the Units and Panels tabs to see annotations, rooms and where each material came from.
The Panels tab lists panels separately, which is why panel counts typically exceed unit counts.
✓ Checked in the product on 19 October 2026
The Units tab also shows a Room column, so units can be inspected per room.
✓ Checked in the product on 19 October 2026
Panels that belong to a cabinet carry both the cabinet and the panel annotation (e.g. C3.P7).
✓ Checked in the product on 19 October 2026Custom or independent panels show only the panel annotation (e.g. P7).
✓ Checked in the product on 21 October 2026
In QC mode the Panels tab can be searched and filtered by cabinet ID, panel type (e.g. shutter, back panel), laminate or edge band.
✓ Checked in the product on 19 October 2026
Searching the Panels tab by a panel type such as "Shutter Panel" lists all matching panels across the project; the header check box then selects them all.
✓ Checked in the product on 19 October 2026
Scrolling through the matching panels shows each panel's core material so a wrongly applied ply can be spotted.
✓ Checked in the product on 19 October 2026Shutters can be checked the same way by searching the shutter panel and reading its core material.
✓ Checked in the product on 19 October 2026Back panels whose core source is the carcass core ('Carcass Core') follow the carcass material automatically; a back panel with its own core ('Custom Core', such as a 6 mm back) keeps it.
✓ Checked in the product on 21 October 2026