Inspect units and panels in the QC Mode tabs
Read the Units and Panels tabs to see annotations, rooms and where each material came from.
The Panels tab lists panels separately, which is why panel counts typically exceed unit counts.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ
The Units tab also shows a Room column, so units can be inspected per room.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ
Panels that belong to a cabinet carry both the cabinet and the panel annotation (e.g. C3.P7).
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલCustom or independent panels show only the panel annotation (e.g. P7).
✓ 21 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ
In QC mode the Panels tab can be searched and filtered by cabinet ID, panel type (e.g. shutter, back panel), laminate or edge band.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ
Searching the Panels tab by a panel type such as "Shutter Panel" lists all matching panels across the project; the header check box then selects them all.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ
Scrolling through the matching panels shows each panel's core material so a wrongly applied ply can be spotted.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલShutters can be checked the same way by searching the shutter panel and reading its core material.
✓ 19 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલBack panels whose core source is the carcass core ('Carcass Core') follow the carcass material automatically; a back panel with its own core ('Custom Core', such as a 6 mm back) keeps it.
✓ 21 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ