Check connectors and collisions in 3D using X-ray and single unit C mode
Spot collisions in X-ray mode and handle exceptions in a single cabinet with single unit C mode.
To check connectors and collisions in 3D, use X-ray mode, where collisions are highlighted in red.
✓ 已于 2026年10月16日 在产品中核实For exceptions in a single cabinet, open single unit C mode, select a panel and view its scenarios.
✓ 已于 2026年10月16日 在产品中核实Modifying a connector in this mode applies the change only to the selected scenario, which removes the rule-following red tick.
✓ 已于 2026年10月16日 在产品中核实The origin corner of a panel is found in the output file, which shows all necessary operations such as hinge drilling.
✓ 已于 2026年10月16日 在产品中核实