Check connectors and collisions in 3D using X-ray and single unit C mode

Spot collisions in X-ray mode and handle exceptions in a single cabinet with single unit C mode.

1. To check connectors and collisions in 3D, use X-ray mode, where collisions are highlighted in red.

   ✓ ଅକ୍ଟୋବର 16, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

2. For exceptions in a single cabinet, open single unit C mode, select a panel and view its scenarios.

   ✓ ଅକ୍ଟୋବର 16, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

3. Modifying a connector in this mode applies the change only to the selected scenario, which removes the rule-following red tick.

   ✓ ଅକ୍ଟୋବର 16, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି

4. The origin corner of a panel is found in the output file, which shows all necessary operations such as hinge drilling.

   ✓ ଅକ୍ଟୋବର 16, 2026 ରେ ପ୍ରଡକ୍ଟରେ ଯାଞ୍ଚ କରାଯାଇଛି