Target the right panel in panel-type conditions

Narrow broad carcass panel conditions to the specific panel so connectors land only where intended.

1. To apply a bottom-panel treatment, target the bottom panel through the panel-type condition (Scenario > Panel 1 > Panel Type = Bottom Panel). The rule's applicability decides which units it covers: it can match a tag, or the unit's own properties such as its width, height or depth, so a tag is needed only when the units are told apart by a tag. For example, legs rules that set the number of legs by cabinet width ranges use no tag.

2. Because the broad carcass panel designation also matches the top panel, a connector scenario meant for a side panel should target the specific left or right panel designation instead, otherwise the top panel can receive connectors unintentionally.

3. To keep connectors off the top and bottom rails while retaining them on the side rails, change the rule's panel-type condition from the broad carcass panel to the specific top panel or bottom panel, or add conditions that it is not the top panel and not the bottom panel.

4. Adding a 'not equal to exposed' condition for the panel types aligns the rule with comparable rules.