Extend a cabinet end panel to the floor or ceiling
Extend an end panel added from a cabinet's End Panel section downward to the floor or upward from its own panel using the Width Extension values.
A cabinet's Construction > End Panel > 'Add Left end panel' puts a separate 18 mm end panel outside the left side panel (the side panel stays), and the menu item then reads 'Remove Left end panel', which takes it off again.
✓ 21 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا
An end panel added from a cabinet's End Panel section is extended down to the floor or upward from the end panel's own panel: Construction tab > Extension parameters > Width Extension, Left / Right in mm.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاOn a wall cabinet's left end panel, Left extends it downward (the cabinet's height above the floor takes it down to the floor) and Right extends it upward.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاAn end panel's own panel (Construction tab) has 'Extend to Ceiling': it extends the end panel up to the ceiling by setting its upward Width Extension to the distance needed.
✓ 21 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاAn extension that would make the end panel taller than the End Panel Max Height in the cabinet's Sizing Rules (set in your catalogue) is refused with 'Extension parameters violate End Panel Max Height' and the value stays as it was.
✓ 22 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاA cabinet's or wardrobe's Sizing Rules (Rules > Sizing Rules > Cabinet: Min / Max width) are enforced when the width is typed: a width above Max width is refused with the error toast 'New width is more than max width.' and one below Min width with 'New width is less than min width.'; the width stays as it was. -1 means no limit.
✓ 21 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا
A cabinet's own sizing rule cannot be set below its current size ('Max width rule is less than the existing width. Please resize or change the width rules.'), and a width above the rule is refused ('New width is more than max width.').
✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاOn a base cabinet, Construction > Skirting Options > Leveller Options > Leveller Height raises the carcass by that amount: 0 -> 50 moved the side panels from 100..820 to 150..870 mm (a toast 'Changed leveller height').
✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیاA strip light added from a base unit bottom panel's Construction > Strip Lights lands on the panel's underside (outside the carcass) by default, with Reference Front and Position 50 mm; Switch Panel Side moves it to the top face inside the carcass and back.
✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا