Cut shapes into a panel using Cut instead of Extrude

Draw a shape on a panel face and use Cut instead of Extrude to make a cut-out or groove at the depth you need.

1. To create a cut-out or groove in a panel, draw the shape (rectangle, circle, etc.) on the panel face, then choose Cut instead of Extrude and enter the cut depth.

   ✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

2. For a through-and-through cut, set the depth greater than the panel thickness (e.g. 30 mm for an 18 mm panel).

   ✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

3. The cut finish can be set to match the panel finish.

   ✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا

4. Copies of the cut can be made with the copy command (CP) and placed at a chosen spacing.

   ✓ 19 اکتوبر، 2026 کو پروڈکٹ میں جانچا گیا