Offset a cabinet bottom panel inward using carcass panel thickness
Raise a bottom panel by one panel thickness so it sits inside the carcass instead of below the side panels.
To move a bottom panel up into the carcass by one panel thickness, select the bottom panel and, on its Construction tab, set Translate Panel > Y to the carcass panel thickness as a positive value (e.g. 18). A negative value (e.g. -18) moves the panel down by that amount, below the side panels and out of the carcass.
✓ 2026년 10월 19일에 제품에서 확인됨Typing the letter c brings up the carcass panel thickness variable, which can be used instead of a hard-coded number.
✓ 2026년 10월 12일에 제품에서 확인됨The panel shifts in by exactly one panel thickness.
✓ 2026년 10월 12일에 제품에서 확인됨