Find and replace a material or edge band in QC Mode
Trace which units and panels use a SKU and swap it for another across the design.
When a finish or material list looks wrong, filter the Panels tab by panel type (for example back panel), select the affected panels and reassign them to the correct material source, then open the Units tab, select all and confirm each core material assignment is correct.
✓ 2026年10月21日に製品で確認済み
To replace an out-of-stock material, open QC mode, go to the relevant Materials Used sub-tab (Core, Finish, or Edge-bands), click the unit count for that SKU to list the units using it, then use the modify menu on those units and click change to pick another material.
✓ 2026年10月21日に製品で確認済み
Core and finish are changed from the materials-used tab; edge bands from the Edge-bands sub-tab.
✓ 2026年10月21日に製品で確認済み
In QC mode, core, finish and edge-band materials can all be changed from within QC mode itself, without returning to the design module.
Core materials can be swapped from the catalogue there (for example changing a ply core from one grade to another).
✓ 2026年10月19日に製品で確認済み
A material or laminate can be located and replaced across the project.
✓ 2026年10月21日に製品で確認済み
The Materials Used tab shows which ply and laminates are used.
✓ 2026年10月19日に製品で確認済み
The Materials Used tab shows where a specific laminate appears in the design.
✓ 2026年10月19日に製品で確認済み
QC can be scoped to a single room (for example the kitchen), and the materials-used view then lists the core and finish materials used by that room's units so each can be verified and corrected from the same view.
✓ 2026年10月19日に製品で確認済み