Infurnia सहायता
Design

partition पर sliding और standard shutter mechanism लागू करें

सही partition पर shutter system जोड़ें और वह mechanism चुनें जिसकी partition अनुमति देता है।

  1. Sliding shutter mechanism (2 से 6 panel) केवल cabinet या wardrobe के outermost partition पर ही लागू किए जा सकते हैं; इन्हें inner division पर लागू करने का प्रयास करने पर त्रुटि दिखती है 'Sliding shutter mechanism can only be applied to the outer partition of a cabinet/wardrobe.'। corner unit में, corner-facing partition पर केवल corner double swing, left bifold, right bifold और single-panel (no swing) mechanism समर्थित हैं, और अन्य जगहों पर standard non-sliding mechanism (single, double, rolling shutter, gas lift, top lift, flap down); असमर्थित चयन 'Shutter System not Supported' दिखाते हैं। Sliding folding shutter mechanism corner unit पर बिल्कुल समर्थित नहीं हैं और उनके अपने त्रुटि संदेश के साथ अस्वीकार किए जाते हैं। साथ ही, corner unit के default partition पर सीधे shutter system नहीं जोड़ा जा सकता; इसे corner unit के अपने shutter-system नियंत्रणों के माध्यम से जोड़ना होगा।

  2. अंतिम door जोड़ने के लिए, parent partition चुनें (पुष्टि करें कि यही highlighted है) और 'add shutter system' का उपयोग करें, फिर प्रत्येक section के लिए double swing जैसा mechanism चुनें।

  3. चयनित partition के स्तर पर, parent partition सहित, shutter system हटाया या जोड़ा जा सकता है। Sliding-folding shutter mechanism अपवाद हैं: इन्हें corner unit में नहीं जोड़ा जा सकता और त्रुटि के साथ अस्वीकार किया जाता है।

  4. एक ही unit के अलग-अलग partition के अपने shutter system हो सकते हैं।

    ✓ 22 अक्टूबर 2026 को प्रोडक्ट में जाँचा गया