Apply sliding and standard shutter mechanisms to partitions
Add a shutter system on the correct partition and pick a mechanism that partition allows.
Sliding shutter mechanisms (2 to 6 panels) can only be applied to the outermost partition of a cabinet or wardrobe; attempting to apply them to an inner division shows the error 'Sliding shutter mechanism can only be applied to the outer partition of a cabinet/wardrobe.'. In corner units, only corner double swing, left bifold, right bifold and single-panel (no swing) mechanisms are supported on the corner-facing partitions, and standard non-sliding mechanisms (single, double, rolling shutter, gas lift, top lift, flap down) elsewhere; unsupported choices show 'Shutter System not Supported'. Sliding folding shutter mechanisms are not supported on corner units at all and are rejected with their own error message. Also, a shutter system cannot be added directly on a corner unit's default partition; it must be added through the corner unit's own shutter-system controls.
To add the final doors, select the parent partition (confirm it is the highlighted one) and use 'add shutter system', then pick the mechanism such as double swing for each section.
A shutter system can be removed or added at the level of the selected partition, including the parent partition. Sliding-folding shutter mechanisms are an exception: they cannot be added to a corner unit and are rejected with an error.
Different partitions of the same unit can carry their own shutter systems.
✓ Checked in the product on 22 October 2026