Control sheet ordering, fractional sheets and where settings are edited
Set sheet ordering, the minimum free length for fractional sheets, and adjust these options from inside a project.
Display Settings offers Sheet Ordering by sheet number or by stack ID.
✓ Checked in the product on 11 October 2026The minimum free length is a configurable value; a leftover shorter than the value you set is not treated as a fractional sheet.
✓ Checked in the product on 12 October 2026These board layout settings, including the utilization mode and the edge-annotation toggles, can be adjusted from within a project rather than only from the admin portal.
✓ Checked in the product on 11 October 2026The minimum free length for a piece to count as a fractional sheet defaults to 250 mm.
✓ Checked in the product on 11 October 2026The minimum free length for a piece to count as a fractional sheet and the split gap between two laminates are both configurable in the Utilization Settings of the board layout settings.
✓ Checked in the product on 11 October 2026