Control sheet ordering, fractional sheets and where settings are edited

Set sheet ordering, the minimum free length for fractional sheets, and adjust these options from inside a project.

1. Display Settings offers Sheet Ordering by sheet number or by stack ID.

   ✓ 11 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ

2. The minimum free length is a configurable value; a leftover shorter than the value you set is not treated as a fractional sheet.

   ✓ 12 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ

3. These board layout settings, including the utilization mode and the edge-annotation toggles, can be adjusted from within a project rather than only from the admin portal.

   ✓ 11 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ

4. The minimum free length for a piece to count as a fractional sheet defaults to 250 mm.

   ✓ 11 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ

5. The minimum free length for a piece to count as a fractional sheet and the split gap between two laminates are both configurable in the Utilization Settings of the board layout settings.

   ✓ 11 ઑક્ટોબર, 2026ના રોજ પ્રોડક્ટમાં ચકાસેલ