Set edge bands on panels before applying finishes

Create edge band entries in the catalogue, assign them per side on each panel or shutter, and change the finish on a single edge from panel level settings.

1. To apply edge banding to cabinet panels, first create the required edge band entries in the catalogue (specifying material, finish, thickness and width).

   ✓ Checked in the product on 10 October 2026

2. Then open the panel or shutter and assign the edge band per side (e.g. front side = shutter-visible band, carcass panels = carcass band).

   ✓ Checked in the product on 9 October 2026

3. To change the edgeband finish on only one edge of a panel, select the panel and go to the panel level settings, then change the finish there. This lets you apply a different finish to a specific edge, such as the bottom edge, without affecting the other edges.

   ✓ Checked in the product on 10 October 2026