Configure skirting, carcass panels and offsets in Construction tab
Set how skirting, carcass panels and back panel offsets appear in the Construction tab so your cabinet's manufacturing output matches the design.
The Construction tab controls manufacturing outputs.
Skirting visibility can be turned on for front, right, left, and back sides.
✓ 已于 2026年10月9日 在产品中核实In cabinet construction, skirting visibility can be turned on or off separately for the front, right, left and back sides. By default only the front skirting is kept on; other sides must be enabled individually. The placement of the skirting depends on the construction setting: with 'Side on Front' the front skirting is placed between the two side skirting pieces, and with 'Front on Side' it runs the full width, covering their ends. This is mainly useful for wooden skirting rather than PVC skirting.
You can define whether the front skirting sits inside or outside the side skirting.
✓ 已于 2026年10月9日 在产品中核实Individual carcass panels (back, top, bottom) can be hidden—useful for sink cabinets where the bottom panel is turned off.
The back panel offset can be adjusted by entering a new value (Carcass > Back Panel > Back Panel Offset).
The back panel's thickness comes from its core material.
✓ 已于 2026年10月9日 在产品中核实