Configure small-part rules and the split margin

Decide when a part counts as small, how far it stays from sheet edges, and how wide the split margin is.

1. The small-part edge rule is applied per part: a part is treated as small when at least one of its sides is below the configured small-part size limit.

   ✓ 12 Ekim 2026 tarihinde üründe doğrulandı

2. Such parts must then keep the configured minimum distance from every sheet edge.

   ✓ 12 Ekim 2026 tarihinde üründe doğrulandı

3. The split margin field sits on the right side of the board layout settings and is enabled only in Half Sheet or Fractional Sheet utilization mode; it is disabled in Full Sheet mode. Its default value is 50, and it can be raised (for example to 100) or lowered (for example to 20) to change the gap between the cut areas of two sheets on the same board.

   ✓ 12 Ekim 2026 tarihinde üründe doğrulandı

4. A thin long panel can be classified as a small part because one of its sides is below the small-part size limit.

   ✓ 12 Ekim 2026 tarihinde üründe doğrulandı

5. A thin long panel classified as a small part must keep the configured minimum distance from every sheet edge.

   ✓ 12 Ekim 2026 tarihinde üründe doğrulandı