Use pre-milling to compensate for edge-band thickness

Apply a per-side pre-milling allowance instead of cutting panels oversize, and decide whether your factory needs pre-milling at all.

1. Premilling can be used as an alternative to adding a fixed extra to the panel cut size when compensating for edge-band thickness: instead of cutting the panel oversize, you can enter a premilling value so the allowance is applied per side on the edgebanded edges.

   

   가이드로 돌아가기✕

   

2. Pre-milling is stored per panel, so the same value is normally applied to all panels.

   ✓ 2026년 10월 19일에 제품에서 확인됨

   

   가이드로 돌아가기✕

   

3. Higher values such as 3 are possible but usually unnecessary.

4. If the factory does not perform pre-milling, the pre-milling option in the cut-list settings can be turned off.

5. If the factory does pre-mill, leave the pre-milling option on.