Split top and bottom panels per vertical partition
Split a cabinet's top and bottom panels into one piece per vertical section so each piece follows its section width and edge pieces extend over the sides automatically.
A cabinet or wardrobe with vertical partitions can have its top and bottom panels split into one piece per section instead of a single full-width panel.
✓ 2026年10月9日に製品で確認済みThe original full-width panel is hidden and replaced by per-section pieces whose widths follow the section widths (with either single or double vertical partition panel construction).
✓ 2026年10月9日に製品で確認済みThe leftmost/rightmost pieces automatically extend over the side panels when the construction has the top/bottom sitting on the sides, so no manual extension is needed.
✓ 2026年10月9日に製品で確認済みThe same per-section splitting applies to the back panel: when the cabinet's back panel exceeds the board size, adding vertical (or horizontal) partitions divides it into one back-panel piece per section, each sized within the board limits, without changing the wardrobe's overall dimensions.
When editing a partition or adding shelves, the correct parent partition must be selected first — if the bottom/parent part is not selected, changes made in the partition settings will not take effect.
Select the parent so the whole section is highlighted, then apply the shelf or partition changes.
To edit a specific partition, first click that partition so it is selected, then open the partition level.
✓ 2026年10月10日に製品で確認済みFrom the partition level you can add a shelf, set its height, add a back panel, or place an appliance.
✓ 2026年10月9日に製品で確認済みConfirm the correct partition is highlighted before editing.
To add a back panel at partition level, select the partition and add the back panel there, then set its back-panel offset to the required value.