Add panels to a box and print its label on the MES Packaging page

Tick panels in the Manual panel selector, confirm adding them to a box, and print the box label to close it.

1. On the MES Packaging page, the Manual panel selector ('Track Panels Manually': a search box, Filter Panels and a table of the work order's panels not yet packed) adds the ticked panels only after a confirmation.

2. Add to Box opens 'Confirm Adding Panels to Box' ('You are about to add N panel(s) to box <box>. This action can be undone later if needed.', with the panels listed) with Cancel and Confirm.

3. After Confirm a toast 'Added N panels to box' offers Undo.

4. A panel put into a box (the Packaging screen's mes_box/create + mes_box/add_panel) counts at once in the work order's Order Progress Packaging figure (0/77 -> 1/77) and under Packaging + Done; removing the box takes it back (0/77).

   ✓ Verificato nel prodotto il 19 ottobre 2026

5. On the MES Packaging page, 'Print label & close the box' first asks 'Print label & close <box>': 'Printing to <printer>. This box has N panels and N hardware lines. The box is closed after printing.', with Cancel and 'Print & close box'. With the PDF Download printer, confirming downloads the box label as a PDF ('Label PDF downloaded.') and closes the box ('Box label sent · box closed'): the box's card turns green, the closed count beside the box total goes up, and the box's button then reads 'Print label'.

   ✓ Verificato nel prodotto il 21 ottobre 2026