Apply sliding and corner shutter mechanisms correctly

Place sliding shutters only on the outer partition and pick a mechanism the corner shape supports.

1. Sliding shutter mechanisms (2 to 6 panels) can only be applied to the outermost partition of a cabinet or wardrobe; attempting to apply them to an inner division shows the error 'Sliding shutter mechanism can only be applied to the outer partition of a cabinet/wardrobe.'. In corner units, only corner double swing, left bifold, right bifold and single-panel (no swing) mechanisms are supported on the corner-facing partitions, and standard non-sliding mechanisms (single, double, rolling shutter, gas lift, top lift, flap down) elsewhere; unsupported choices show 'Shutter System not Supported'. Also, a shutter system cannot be added directly on a corner unit's default partition; it must be added through the corner unit's own shutter-system controls.

2. To add the final doors, select the parent partition (confirm it is the highlighted one) and use 'add shutter system', then pick the mechanism such as double swing for each section.

3. The available choices depend on the corner shape.

   ✓ 10 அக்டோபர், 2026 அன்று தயாரிப்பில் சரிபார்க்கப்பட்டது

4. L corners offer Corner Unit Double Swing, Left Bifold, Right Bifold and None.

   ✓ 9 அக்டோபர், 2026 அன்று தயாரிப்பில் சரிபார்க்கப்பட்டது

5. Pentagonal and blind corners offer Single Swing, Double Swing, Single Lift Up, Double Lift Up, Flap Down, Rolling and None.