Remove or switch off panels on a single cabinet
Change a unit's construction carcass settings so unneeded panels are removed only for that placement.
To remove a panel such as the top or back panel from a single unit, select that unit in the design and change it in the unit's construction carcass settings rather than editing the component definition, so the change applies only to that placement.
The bottom panel can be turned off from the carcass section of the cabinet's Construction tab.
✓ 2026年10月10日に製品で確認済みThe bottom panel can be turned off from the carcass section of the cabinet's Construction tab; this is a cabinet-level change, so it applies to the selected cabinet rather than to individual panels.
✓ 2026年10月10日に製品で確認済みSwitch off the panels that are not needed (for example the back panel) in the unit's construction settings.
Then set the required width, height and depth on the unit.