Add accessory drilling to a panel via panel hardware

Place an accessory such as a lock on a panel as panel hardware, position it relative to the panel size, and check the drill positions in 2D CAM mode.

1. To place an accessory such as a lock on a panel, open the panel and add it as panel hardware.

   ✓ Vérifié dans le produit le 10 octobre 2026

2. The hardware is inserted at the panel centre by default.

   ✓ Vérifié dans le produit le 10 octobre 2026

3. Reposition it from the furniture/type position settings, using parameters relative to panel width and panel depth (for example panel width minus an offset) so the position updates with the panel size.

4. Verify placement by entering 2D CAM mode on the panel, where distances and drill positions can be measured.

5. To confirm a panel's drilling positions are correct, select the panel, enter 2D CAM mode, and open the dimensions. This displays all the measurements (e.g. centre-to-centre distances and edge distances) so you can check them against the intended values and correct any that are off.

   ✓ Vérifié dans le produit le 11 octobre 2026