Restore a removed shutter system on a partition

Add a single swing shutter system back to a partition whose shutter system was removed, and see how shutter configurations and reduction settings behave.

1. A partition whose shutter system was removed offers 'Add Shutter System' in its Partition options.

2. 'Add Shutter System' adds a single swing shutter system at once (no catalogue to choose from).

3. A configuration (a ready-made set of shutter design, profiles and mechanism) comes from Shutter System Config instead.

4. Choosing None removes the unit's shutters, with the notice 'Changed Shutter System'.

5. In a rolling shutter wall unit (mechanism rolling_shutter) the shutter system's Reduction > Side rows (Left, Right, Top, Bottom, each 1 as placed) pull the shutter in from that side by the value set (Left 1 -> 20 moved its side 19 mm in, Top 1 -> 30 brought its top 29 mm down), while the main partition's Width / Height rows are disabled and its shelves and sub-partitions do not move.

   ✓ Comprobado en el producto el 19 de octubre de 2026

6. A partition's Subpartition Ratio (Partition > Subpartition Ratio > Use Subpartition Ratio, Construction tab) shares the sub-partitions' total height by the ratio values typed: 2 (upper) : 1 (lower) turns 973 / 973 into 1297.3 / 648.7.

   ✓ Comprobado en el producto el 19 de octubre de 2026

7. Deleting a shelf with its own delete button removes the two partitions it divided and everything inside them, and leaves the partition it split as one undivided partition: the loft shelf's delete in a partition holding 7 sub-partitions left the wardrobe with 3 partitions (root, that partition, the lower one), toast 'Deleted Shelf'.

   ✓ Comprobado en el producto el 19 de octubre de 2026

8. A partition's Add Shelves > Add shelves field is an action, not a count: entering a number adds that many shelves to the partition and the field reads 0 again; entering 0 removes no shelf (the same for Add Vertical Partitions).

   ✓ Comprobado en el producto el 19 de octubre de 2026

9. With a partition that holds an appliance selected, the Partition section lists 'Existing Appliances / Accessories' (each with a remove button) above 'Add Appliances / Accessories'; a partition without one shows only 'Add Appliances / Accessories'.

   ✓ Comprobado en el producto el 21 de octubre de 2026