Extend a panel to a target depth, back or front

Enter the right extension amount so a panel reaches a target depth, runs to the back or pushes past the carcass.

1. To extend a panel to a target overall depth, open the panel's Depth Extension parameters and enter the extension amount as the target depth minus the panel's current depth (e.g. 350 on a 100 mm panel gives 450 overall); this is done per panel in the design.

   ✓ ২২ অক্টোবর, ২০২৬ তারিখে প্রোডাক্টে যাচাই করা হয়েছে

2. To make a panel run to the back, open the panel-level construction menu and use the Back Extension parameter, entering the extension length needed (the cabinet depth minus the panel's existing depth).

   ✓ ২২ অক্টোবর, ২০২৬ তারিখে প্রোডাক্টে যাচাই করা হয়েছে

3. To push a panel out past the carcass, enter the extension amount on the panel's front edge; the panel's edge labels guide you to the edge to extend.

4. To leave clearance above a drawer, select the panel, open its panel section and reduce its size by entering a negative value equal to the amount to be removed, depending on how much space should remain.

5. A right extension offset can be set on an individual panel from its Construction tab to close a gap; the same value can then be entered on the other panels.